Faco

I have made a schema, thanks. With the tester I got continuity when trying these couples: AL + AR, AL + G2, AL + G1 . Led light is Green. So cables seems to be good. Could be a problem with charge station or his power unit?

Hi! I am looking for some help with my husqwarna 430X, it is ready to start the 4th year of work, but there is something wrong and this time I cannot find a solution. Robot seems fine, the charge base has a fixed green light, all seems ok BUT it is unable to reach the charge base and when it reaches one area of the garden it says "No cable signal" or "Out of Working Area". I have checked perimeter wires and guides with a tester, there is continuity on all four connectors of the charge base. So seems that no cable is broken, and the green light confirms that. I have tried to reset all the settings of the robot, then I have tried to pair it to the charge station again but nothing has changed. The robot "bounces" on one of the guides and does not work after such guide. In an another place of the same area after the bouncing guide, the robot says "no cable signal" or it works for some meters and than stops with "Out of working area". If I put it in the charge base and I do start the work, it does go back and then it stops with the error message "Out of working area". There should be no broken cable in such area because nobody has made any change or made any work in the last months. The robot was working when I put it the garage past year. Does anybody have some suggestions about things that I can try? Is there any other step to take to have the robot learn area, guides and perimeter? Thanks!